Things to Consider for Preventing Fastener Overdriving

The following are certain things which you just cannot afford to neglect if you want to drive bolts, without overriding them.

Drill Pilot Holes: Pilot holes are generally holes that are drilled into the material creating a hole for driving fasteners. These holes have a small diameter & prevent the fasteners from overdriving or snapping in half. This helps lessen shear capacity reduction by a significant amount. To know more about fasteners manufacturer in Australia.

Determine the Proper Driver’s Slip Clutch Setting: Slip clutch is an adjustable collar, which is used to control the torque transferred to the bolt’s head for driving it. It is important to adjust the driver’s slip clutch setting so that it matches the amount of torque required for driving the fastener. Failure in setting the correct amount of torque can result in overdriving. The slip clutch setting for softwood is different than that required for hardwoods or metals. A little torque is required in the case of softwoods, whereas for metals you are required to have a higher torque setting. Click here to know more about fasteners supplier in Australia.

Go for Self-Centering Bits: When you are drilling slots for driving the fasteners it can get difficult for a person to be able to drill a slot within a millimeter precision. Remember, if the slot is not drilled properly & the hole is misaligned from the center, it can lead to driving the fastener in the wrong direction. To prevent this from happening, it is highly advisable to use self-centering bits, which deliver greater precision for drilling slots. Thus, it helps to prevent overdriving as well as maintain shear capacity. To buy fasteners visit fastener dealers in Australia.

Keep Practicing: It is hard to achieve perfection on the first attempt. You will have to keep practicing the process of driving a fastener. Only after repeating the process for quite a number of times will you master the skill & be able to drive bolts without overdriving them.