Flanges Manufacturers in India

The Flanges are superly designed to fit the criteria dictated by the industry and is offered at affordable rates. A flange is connected to pipes, valves, pumps and other equipment to form a piping system. Flanged joints are made by bolting together two flanges with a gasket between them to provide a seal.

Types of Flange manufacturer

1.Slip on Flange:- The calculated strength from a Slip-On flange under internal pressure is of the order of 2/3 that of Welding Neck flange, and their life under stress is about 1/3 that of the latter.

2.Weld neck Flange:- Welding Neck Flange is easy to diagnose at the long tapered hub, which goes gradually over to the wall thickness from a pipe or fitting.

3.Long weld neck Flange:- The long neck guides the pipe into the flange itself and provides reinforcement that a standard weld neck flange cannot.

4.Blind Flange :- Blind Flanges are manufactured without a bore and used to blank off the ends of piping, Valves and pressure vessel openings. However, most of these stress are bending types near the center, and since there is no standard inside diameter, these flanges are suitable for high-pressure temperature apps.

5.Lap joint Flange:- Lap Joint Flanges have all the same common dimensions as any other flange named on this page however it does not have a raised face, they used in combination with a "Lap Joint Stub End". these Lap Joint flanges have a certain special advantage:

• Free to swivel around the pipe facilitates the lining up of opposing flange bolt holes.

• Lack of contact with the fluid in the pipe often permits the use of inexpensive carbon steel flanges with corrosion-resistant pipe.

• In systems that erode or corrode quickly, the flanges may be salvaged for reuse.

6.Threaded Flange :- Threaded Flange are used for special circumstances with their main advantage being that they can be attached to the pipe without welding. Sometimes a seal weld is also used in coincidence with the threaded connection.

7.Socket Weld Flange:- Socket-weld pipe flanges are attached by inserting the pipe into the socket end and applying fillet weld around the top. This Socket weld flange are typically used on the smaller size of high-pressure pipes. These allow for a smooth bore and better of the gas inside of the pipe.

Source Link: https://www.pipefitting.in/index.php